Brush guard bolts

One of my friends gave me his brush guard off of his RZR S. It had some dents on it and a little bit of rust.

I am going to sand it and paint it.

I noticed I dont have the bolts to put it on. Does anyone have any or know where to get them without having to buy a new brush guard?

Thanks in advance!

What type of brushguard? If it mounts in factory holes then I would take your machine and trailer it down to the Home Dpeot of Lowes. Get an idea of the right size and thread, go in and get the bolt and bring it outside and try it. If it doesn't fit, try another. It might be a pain but you can almost guarantee they will have the right bolts, and it would be much cheaper than buying a new brushguard.

Its the factory brush guard. Gosh thats a whole lot of trouble to go through to find bolts.

TBONE21 wrote:

Its the factory brush guard. Gosh thats a whole lot of trouble to go through to find bolts.

TBONE21 just go by Carolina Polaris there in HighPoint. See Dustin or Johnny. Tell them you're 1 of the WVSXS gang & that Randy sent you by. I'm sure they"ll help you out without buying a new bumper.

TBONE21 wrote:

Its the factory brush guard. Gosh thats a whole lot of trouble to go through to find bolts.

Yeah maybe. Just trying to offer you a suggestion.

If you think that would be a pain running in and out of the store, just wait until you try to start the nut onto the 2 bolts that will underneath the front diff. Another set of hands will save a lot of cussing and wrench throwing!!!!

If you have a NAPA auto parts store that would be easier than Home Depot or Lowes since it will be a whole lot less walking back and forth because the stores are small and you usually can pull right up to the front door I know I can at the one near my house

Hey, all I am saying is "No bolts= no brushguard mounted" A few minutes of aggravation to get the bolts = getting the brushguard on. Call me crazy....

hey I can weld it on! haha j/k

TBONE21 wrote:

hey I can weld it on! haha j/k

True!