2011 RZR S problems?

I know the 2010 rzr s had a tranny issue but do any of the 2011's have any problems?

so far knock on wood havent had any problems with my 2011 ranger RZR ~~~~~~

Only problem so far has been with the vent lines melting.

Only problem so far has been with the vent lines melting.




what vent lines are you talking about so i can keep an eye on mine ??????????

You also have a deep lonely feeling as you look back and no one is behind you , but medication should help , counseling , Speech theropy ( as all you seem to be able to say is "Shit " " Damm" " Holy Crap " ).

The clear tubing (vent line) that comes from the rear differential and runs up into the firewall behind the seats. The tubing runs through a clamp on the motor that is close to the header. You can find more information on this in another thread on here.

Mine actually melted completely in two within probably two miles of riding. Most I've read about only had the tubing melt so that it closed up preventing it from venting. Definitely keep an eye on it.

The clear tubing (vent line) that comes from the rear differential and runs up into the firewall behind the seats. The tubing runs through a clamp on the motor that is close to the header. You can find more information on this in another thread on here.

Mine actually melted completely in two within probably two miles of riding. Most I've read about only had the tubing melt so that it closed up preventing it from venting. Definitely keep an eye on it.




THANK YOU I SURE WILL BE KEEPING AN EYE ON THAT TYTYTYTYT

Here is a link to the thread I was referring to.

https://wvsxsriders.forumotion.com/t3370-check-your-2011-rzr-for-melting-issues?highlight=melting

The clear tubing (vent line) that comes from the rear differential and runs up into the firewall behind the seats. The tubing runs through a clamp on the motor that is close to the header. You can find more information on this in another thread on here.

Mine actually melted completely in two within probably two miles of riding. Most I've read about only had the tubing melt so that it closed up preventing it from venting. Definitely keep an eye on it.


SURE ENOUGH ITS SOMEWHAT MELTED PFFFFFFF CAN YOU SAY WARRANTY WORK

it sounds like to me thats the only problem with the 2011's

Tbone, every sxs has it's good and bad, and has a few little probs. It's a big investment, so you need to ride everything in the woods not a parking lot. Then buy the one you liked riding the most.

If I make it to the ride next weekend, you are more than welcome to ride my S for a while and see what you think.

Oh, and Tbone

500 miles and no problem out of mine not even the vent tubes.

That vent tube problem sure ain't very cool. Venting may be one problem it causes, but if its melting off down that low, your gonna get water in that vent tube the very next time you go through a deep water hole!!!!That could be disasterous.

i resolved my vent tube from melting while @ James for ride i ran it up the frame and up and out the front of the bed over roll cage and back down inside the bed the water has to go up 12 inches before it can go to anything now and not even close to anything that will melt it

Yeah, good idea. I've got every one of my vent tubes snorkled up into cab area. I think 5 of them altogether. To me it appeared that all vent tubes were short enough from the factory that given the right conditions, water could get in. So i ran all of them up.