Snorkel install

My buddy and I decided to snorkel our rzrs recently. Going on a ride up in Pa some where and there is suppoosed to be some deep water crossings. Ordered this kit off ebay from Artic Thunder Kustoms. Didn't feel like doing the cutting and fitting necessary if I went to Lowes. My back is killing me. The pipes are pressure tested and it comes with some end caps for transport and storage.

This is his 2011 with some stuff removed.
The only problem with the kit is it took a little head scratching to figure out which pipe went where.

Connected the vent lines together for one vent hose going up, passenger side, and exiting under Hot Rod Rino's roof. The gas vent goes up by itself behind the driver and under the roof.

This is the finished product. No storage space is lost in the bed. The pipes are off to the side so the rear view is not blocked. They are protected behind the roof so hopefully no tree limb problems. There is no additional noise that I can tell. While there I greased up all the electrical connections. This install is mainly a safety precaution. I don't intend to go deep but you never know. If anyone noticed anything I missed then let me know. I would appreciate it. I forgot. The hose from the valve cover to the air filter box was replaced. It has a slit in it from the factory.

Looks good...

Looks good!! I like it!

That's cool the problem I ran into when I did mine 4 times was additions, back EMP glass then EMP bed cover. With the cover I have all my food,block n tackle for the winch, tools,belt etc, plus on the out side room for 2 gas cans n an ice chest, I hate snorkeling it is time consuming n it hurt my back too!!!

good looking job..