1800 mile maint.

ok guys I have 1800 miles on our rzr she is an 08 (nov 07 build date ) my daughter wants to change the body color and Im doing a major once over , what all do I need to check / or service ? I do notice a lot of dirt build up around the breather on the valve cover like it may have some blow by . also want advise on bodys and would like to put a temp guage on her !
any advise ???

Check all bushings,wheel bearings,tie rod ends,brake pads etc.Also change all fluids.Check your owners manual to make sure what is necessary before spending money.You can buy new plastic from the dealer that is made just to paint so you can choose what ever color you want.

how about the majier plastics do the fit pretty good ? I have one tie rod that has a lot of lose motion and one wheel bearing (left rear ) . the a arm bushing in the front seem to have some play in them . should I go back with stock or is there something out there better ?

If it hasn't already been replaced, change the clutch drive belt. Depending on how well aligned your sheave faces are, I've ridden with folks whose belt failed @ 1200 miles.

porkchop wrote:

ok guys I have 1800 miles on our rzr she is an 08 (nov 07 build date ) my daughter wants to change the body color and Im doing a major once over , what all do I need to check / or service ? I do notice a lot of dirt build up around the breather on the valve cover like it may have some blow by . also want advise on bodys and would like to put a temp guage on her !
any advise ???

I can supply info on temp and volt gauge...just give me a hollar when you are ready.(PM... and I will give you my cell #)

how about the aftermarket bodies ? how is the quality, (fit and finish)

porkchop wrote:

how about the aftermarket bodies ? how is the quality, (fit and finish)

I like them! Bobby D got a new body on his RZR and it looked great! I liked it a ton and when I redo my RZR one day, I am going to use whoever he used. I am pretty sure it was an aftermarket company and it looked real good!

I got the Maier plastic and my RZR is a 1st Generation 2008 and it has some issues to make it work but other than that I like it.If your RZR is a Gen 2 or 3 it may work better

You can get a full set of plastic for Polaris for $500 and it comes black. You'll have to paint it or get it painted but it fit pretty good on my RZR and it's a gen 3. but if you just want a solid color probably going with what bobby did would be cheapier.

im trying to get some plastic my self it maier sells to me again i will post it up and get you some plastic cheap dealer cost !

COOL , I WILL WAIT A LITTLE BIT THEN !