rzr s ball joints

My ball joints have about 1/8" of slack up and down. I'm going to get new ones this week. I will be greasing this set, and my tie rod ends from now on. They have those needles for the end of a grease gun at Autozone. I took the tie rods loose and took the boots off, cleaned them up, and greased the poop out of them. I'm thinking the needle will slide under the boots without poking a hole in them. The tie rod ends were bone dry, not one sign of grease from the factory.

find someone with HD ones....

WV Hot Rod Rhino wrote:

find someone with HD ones....

I ordered some Polaris ones, and it said they had been replaced with a new part and part number. Hopefully that means they made an upgrade.

I'm gonna try the grease in this set, and see if I get more than 1100 miles out of them. I took them out and worked them by hand, and could hear dirt/rust in there crunching around.

yea...I had to replace my tie rod ends and lower ball joints and all brake pads at 1400 miles....but you got to pay to play......

bubba53 wrote:

yea...I had to replace my tie rods and lower ball joints at 1400 miles....but you got to pay to play......

Parts, beer, and gas, can get real expensive real quick. + =

1100 miles is not bad. i got 2000 on my rzr and only replaced the front bushings once. but now need bushings on lower front tierods balljoints and the second set of rear brake pads. still on factory front pads