Under seat block off

I noticed on my last ride ( there was lots fo water ) that I had a huge amount of steam comming into the cab , The only recent change has been adding a S header ... So Decided to make some block offs to help some fo the free flowing water into the cab and the steam ...
No block offs

Passanger and center done



Complete all the way across



I wish I had a good way to shape the plasitc over the gas tank but did not want to take any chances with it rubbing the fuel lines or vent lines .....

After the last ride I also cut and drilled my A arm guards , I had sticks rocks ETC packed in so tight that I could not get my hand in to pull it out ... So I cut a oval shape that will allow me to get my hand in to pull that stuff out , and some drain holes along the A arm to help it drain .... I would consider taking them off but saw several good hits on them .....



The pile of crap I pulled out of the A arm guards , hard to tell but it was mostly stick and rocks .....

Looks great Drew, how are you attaching the block off pieces?

Looks real good Drew! We stopped running our a-arm guards for that reason.

You end up with 3 square sides , so it basicly holds its self in place , but the seat will hold it in place while riding but will still allow me to take them out to clean ....

WV Hot Rod Rhino wrote:

Looks real good Drew! We stopped running our a-arm guards for that reason.

I maybe considering that if this does not help , one stick was rubbing the boot , luckly no puncture that it would have had nothing holding it there if the gaurd was not there ....

Thanks for the info.

Thats a great idea

bubba53 wrote:

Thats a great idea

All is right with the world if Bubba likes it .....